Product introduction:
Cs-9804c LED soft light strip silica gel is a condensation type room temperature curing silicone potting adhesive, which is a special potting adhesive for surface glue dripping LED soft light strip. Compared with epoxy potting adhesive, Pu potting adhesive, this series of glue has the following remarkable characteristics:
1. It has excellent water resistance, which can protect the lighting from water erosion and long-term water lighting without fog;
2. It has excellent heat dissipation, which can ensure that the chip will not affect the service life due to the high temperature in the use process;
3. It has excellent light transmittance and refractive index, which can greatly reduce the light attenuation of the light source;
4. It has super anti ultraviolet ability, which can ensure that the lighting can be used outdoors for a long time;
5. It has excellent weather resistance, which can ensure the normal use of lighting in a wide temperature range (- 40-220 ℃) and under water and other special environments, so that the use area of lighting is almost unlimited;
6. This series of products belong to room temperature curing type. Its main curing mechanism is curing by reacting with water in the air, so it is not sensitive to temperature, which makes its curing conditions simpler and easier to operate.

Usage and precautions
1. Mix the glue of components a and B evenly according to the ratio of 4:1 by weight; (make sure that no other impurities are brought in when mixing the glue, Zui is good at using clean special containers and mixing rods);
2. Put the mixed glue into the foam exhausting device for foam exhausting, and then fill and seal it after the bubbles are eliminated; (because the surface tension of silica gel is low, the colloid is easy to overflow the container during the foam exhausting process, so Zui is good at using a container with four times the volume of colloid or using intermittent foam exhausting method for foam exhausting, that is to say, in the vacuum state for 10 seconds, after the bubbles accumulate, close the vacuum machine quickly , make it return to normal pressure, so that after repeated several times, the bubble can discharge the colloid without overflowing the container);
3. Transfer the foam discharged glue into a special pouring container or equipment for filling and sealing; (the volume of the glue will shrink during the curing process, so fill it up as much as possible during filling and sealing, and it will be more beautiful after curing);
4. After the colloid surface is dry for 1-2 hours (the surface is not sticky), the lamp strip can be removed from the operation platform for subsequent operation;
Special reminder
&1. This glue cannot be mixed with other glue;
&2. The mixture of the two components should be as uniform as possible;
&3. If the conditions permit, the mixed glue should be treated as far as possible;
&4. The prepared glue must be used up within the operable time to avoid unnecessary waste;
      5, when used as a surface drop, it is recommended that customers can drop the gel after the first time, then reconfigure the gel for second times until the gel is cured, and the appearance will be better after curing.
&Nbsp; & nbsp; & nbsp; 6. As a result, the series of glue will react when encountering water, and the unused glue must be sealed. The best storage condition is room temperature and shade.
&7. This product should avoid long-term contact with washing water, organic solvent such as Tianna water and strong acid and alkali.
&8. Since the materials and processes used by different customers are beyond our company's control, we must carry out matching test and sample before using the glue. After the sample is qualified, we can use it safely.